Kodak i5800 Accessory Manual

A-61731 / February 2011
Installing and Using the Manual Feed Shelf
Following are instructions for installing and using the Manual Feed Shelf for use with Kodak i5800
Scanner. The manual feed shelf includes: the manual feed shelf and two side guides.
The Manual Feed Shelf provides a flat work surface to aid in manual feeding.
1. Before you begin, open your scanning applica-
tion and set the scanner's input elevator in the
lowest position (i.e., 750-sheet).
2. Open the side guides on the input elevator to
the widest position and verify that the side
guides are opened up. The shelf cannot be
installed if the side guides are folded down.
3. Open the scanner cover.
4. Locate the two rails on the left and right side of
the transport and slide the manual feed shelf
over both of these rails.
The manual feed shelf has two locations for the
side guides.
NOTE: The side guides are optional. It is not
necessary to install them if you do not want
to use them.
Depending on the size of the documents you are
scanning:
• use the holes closest to the center of the manual
feed shelf if you are scanning documents
smaller than 21.59 (8.5 in.).
• use the holes farthest away from the center of
the manual feed shelf if you are scanning
documents larger than 21.59 (8.5 in.).
5. After inserting the manual feed shelf, install the
side guides. Align the holes on the manual
feed shelf with the pegs on the left side guide
as shown.
6. Insert the right side guide in the same manner
as in Step 5.
Part No. 7J4317