Kodak i5000 series User Manual page 52

Installing/Replacing
the ink blotter strips
4-6
The three ink blotter strips on the scanner transport collect ink overflow from
the printer. These strips should have been installed in the ink blotter channels
at the time of printer installation. If they have not been installed, the following
steps can be performed to install these strips for the first time.
Replace these strips as ink overflow collects on the blotter(s). Depending on
your print position, all strips may not need to be replaced at the same time. To
order additional ink blotter strips, see the section entitled, "Supplies and
Consumables" in Chapter 6.
1. Pull the scanner cover release latch forward to release and lift the scanner
cover.
2. Remove the black drainage strip from the transport.
3. Locate the blotter strip channel. These channels are where the blotter
strips will be installed or replaced.
4. If you are replacing a blotter strip, proceed with Step 5. If you are installing
the blotter strips for the first time, go to Step 6.
A-61670 February 2013