Scanning Documents - Kodak i5000 series User Manual

Scanning documents

3-8
The scanner must be enabled to scan documents. This is done through the
scanning application. After enabling the scanner, depending on how your
scanner is configured, your scanner will either automatically start scanning
(i.e., auto start), or will start scanning when you touch the Start/Resume
button on the scanner. For more information, see the documentation that
supports your scanning application.
1. After you prepare your documents according to the guidelines in the
previous section, be sure your scan job is set up in your scanning
application as desired.
2. Place the documents you want to scan in the input elevator.
3. Start scanning via your scanning application.
Depending on how your scanner is configured, the touchscreen will display
either the Scanning screen or the Paused screen.
Auto start options:
TWAIN: Automatically start scanning
ISIS: Automatically start transport
VRS: ADF (Auto start enabled) / Panel Feed (Auto start disabled)
See the Scanning Setup Guides for TWAIN, ISIS and VRS for more
information
This screen will be displayed if the
auto start option is enabled in your
scanning application:
NOTE: If your scan job requires a temporary override (i.e., printing,
multifeed detection, etc.), then the auto start option must be
disabled prior to starting your scan job to allow access to the
Overrides screen.
Alternatively, pressing Stop/Pause while scanning will also
provide access to the Overrides screen.
For more information, see the section entitled, "Scan job
overrides".
4. Touching any of the options displayed on this screen, will perform the
action (i.e., Omit Printing, Omit Multifeed, Allow Maximum Length, etc.) on
the next document only. To perform these actions for the rest of the scan
job, see the section entitled, "Scan job overrides" later in this chapter.
5. You must press the Start/Resume button to begin scanning if auto start has
been disabled by the scanning application.
This screen will be displayed if the
auto start option is disabled in your
scanning application:
A-61670 February 2013