Kodak i5000 series User Manual page 57

Length Protection Enabled
for portrait scanning
A-61670 February 2013
Documents that may not stack reliably in Stack #2
• Documents with folds perpendicular to the direction of the document
transport
• Documents in poor condition
• Documents with lead edge curl or damage
• Documents less than 8 inches and longer than 12 inches
• 110 lb. index paper of any size
• Lettersize 28 lb. bond paper
• A4 size 70 lb. offset paper
• Any size onionskin paper, NCR paper or photographs
• Lettersize 200 lb. index paper
• A4 size 90 gsm paper
NOTE: Even though the conditions listed above may not be reliable stacking
conditions, they may stack well under some circumstances.
Other factors that can effect stacking
• High and low humidity can cause documents to stack differently.
• Air disturbances, such as people walking near the scanner, fans, air vents,
etc. may cause documents intended for Stack #2 to not stack properly.
• Exceeding the recommended stack height (200 documents, 20 lb. bond
paper in good condition) in Stack #1 may prevent documents from stacking
properly in Stack #2.
• Use of the magnetic side guides can greatly improve stacking neatness.
• Curled lead edges may increase or decrease Stack #2 stacking reliability
depending on the direction of the curl and the paper type.
• Documents with lead edge tears, corner folds, tri-folds, bi-folds can have an
unpredictable effect when depositing into Stack #2.
The Controlled Dual Stacking Accessory has been designed for stacking when
feeding documents in landscape orientation. Stacking documents longer than
8.5 inches (215 mm) may not be possible and is dependent on the type and
condition of the pages that are to be deposited in Stack #2. To prevent poor
stacking of landscape pages, the Controlled Dual Stacking option, by default,
will cause a jam condition if a page longer than 8.5 inches (215 mm) is
scanned when stacking is enabled.
The message, Length Protection Enabled will be displayed on the Operator
Control Panel to indicate that the maximum document length limit is in effect. If
you want to stack documents longer than 8.5 inches (i.e., Portrait orientation),
you should contact Kodak Service for assistance.
NOTE: The Allow Maximum Length override will not disable Controlled Dual
Stacking Length Protection.
5-3