Table of Contents
Advertisement
Error
code
E061
E062
E089
E099
E302
E303
E304
E401
E402
E410
E478
E479
E486
E487
Descrpton of error
Memory switch data error
When memory swtch data s broken or revson s old.
Sewing data error
When sewng data s broken or revson s old.
When sewing products are stacked and passing
Remove sewng products.
Interference of knife lowering command with
thread trimming motion
When nsertng poston of knfe command s mproper
and knfe command nterferes wth thread trmmng
moton n case of moton from external data.
Confirmation of tilt of machine head
When tlt of machne head sensor s OFF.
Main shaft semilunar plate sensor error
Semlunar plate of sewng machne motor s abnormal.
Cloth cutting knife sensor error
When knfe s held lowered or sensor s not OFF when
knfe s lowered.
Copy disapproval error
When tryng to perform copyng to the pattern No.
whch has been regstered.
Pattern deletion error
When tryng to perform deleton n case the remanng
pattern No. whch has been regstered s only one.
When sewing counter set value is smaller than the
number of times of sewing of the sewing pattern
which is selected at present.
Carriage movable range over error, left
Feed amount of sewng pattern s over the movable
range of carrage (left sde).
Set the jump feed amount and sewng length so that
the left travelng amount of carrage s wthn 25 mm.
Carriage movable range over error, right
Feed amount of sewng pattern s over the movable
range of carrage (rght sde).
Set the jump feed amount and sewng length so that
the rght travelng amount of carrage s wthn 610 mm.
Eyelet knife length error
When the shape s not formed snce the eyelet knfe
length s too short n case of eyelet shape.
Eyelet shape length error
Eyelet shape length s too short to form the shape n
case of eyelet shape.
− 84 −
How to
Place of
recover
recovery
Turn OFF the
-
power.
Turn OFF the
-
power.
Possble to
Automatc
re-start after
sewng screen
reset.
Possble to
Data nput
re-start after
screen
reset.
Possble to
Data nput
screen
re-start after
reset.
Turn OFF the
-
power.
Turn OFF the
-
power.
Possble to
Pattern lst
re-start after
screen
pressng can-
cel button.
Possble to
Pattern lst
re-start after
screen
pressng can-
cel button.
Possble to
AC data nput
re-start after
screen
reset.
Possble to
AC data nput
re-start after
screen
reset.
Possble to
AC data nput
re-start after
screen
reset.
Possble to
Sewng data
re-start after
nput screen
reset.
[S17]
Possble to
Sewng data
re-start after
nput screen
reset.
[S14]
Advertisement
Table of Contents
