JUKI AC-172NN-1790 Instruction Manual page 24

@9
@6
#0
17) Loosen two screws #1 . Adjust the heght of preset table #0 so that t snks by 1 mm when clamp @6
comes down to ts lower poston.
@6
@6
B
A
– 20 –
16) Tghten two setscrews @9 to
leave a 10-mm long slot n the
top surface of the clamp @6 .
When the setscrews are tght-
ened to leave a 20-mm long
slot there, clamp @6 s pos-
tioned as shown in the figure.
@6
18) If you want to change the lftng/lowerng speed
of clamp @6 , adjust speed controllers A and B.
To reduce the lowerng speed of clamp @6 ,
tghten speed controller B.
To reduce the lftng speed of clamp @6 , tghten
speed controller A.
#1
#0