Setting Of The Number Of Rotations; Reverse Feed Stitching - JUKI LZ-2290A-SR/IP-110D/SC-916 Instruction Manual

6-7. Setting of the number of rotations

The number of rotations can be set at each pattern (cycle stitching is not possible to set the number of rotations).
Setting of the number of rotations can be performed in the reverse feed stitching setting second screen (when
the pattern is the overlapped stitching, perform it in the overlapped stitching setting second screen).
Reverse feed stitching setting second screen
1 : Number of rotations is set. 200 to 5,000 can be set in increments of 200.
Number of rotations is limited by zigzag width, feed amount, function setting No. 96 Max. number of
rotations setting, etc.
In this case, the minimum setting is prior.
There are cases where the shapes are not stabilized in case of some custom patterns which frequently
repeat normal and reverse feed stitching.
In this case, set the sewing speed at approximately 2,000 sti/min.

6-8. Reverse feed stitching

OFF ON
1
A
Sewing
pattern
OFF OFF
2
Reverse feed stitching setting screen
q
w
For the reverse feed stitching, there are standard condensation, 2-point condensation and condensation custom.
1
1
OFF ON
A
B B
C C
D D
ON ON
Reverse feed stitching can be set with each zigzag
pattern.
Effective/ineffective of reverse feed stitching can be set
by pressing reverse feed stitch at sewing start switch 1
and reverse feed stitch at sewing end switch 2 . In case
the reverse feed stitching is effective, the respective
shapes of the reverse feed stitching are displayed. In
case of ineffective, the shape is not displayed.
71