Table of Contents
Advertisement
Custom Key (for use with optional remote only): allows you to assign a dif-
ferent function to the Custom key on the optional remote to quickly and eas-
ily use the effect. Only one effect can be enabled at a time. The default is
Source Info; highlight an effect and press Select to choose a different one.
Blank: shows an empty screen.
Mute: turns off all sound.
AV Mute: turns off all sound and displays a blank screen.
Aspect Ratio: sets the ratio of the image width to image height.
Source: cycles through the available sources.
Auto Image: causes all sources to be reacquired.
Freeze: pauses the projected image.
Magnify: allows you to enlarge a section of the projected image.
Ruled Lines: displays line patterns that are useful when projecting onto a
writeable surface, or when installing and setting up the projector.
Split Screen: enables or disables Split Screen. Before using this for the
first time, configure Split Screen sources and layouts using the Split
Screen menu.
Source Info: displays the Source Info menu.
Service Info: displays the Service Info menu.
Network: The projector has an RJ45 Ethernet connector that supports net-
work connections and TCP/IP protocols. This will allow for the control and
management of the projector over a corporate network. Visit our website for
complete details on using the networking functionality. The following fields
are accessible when DHCP is not checked and available for manual entry of
data.
For network control, you can access the projector through Port 23 (Telnet).
We use the same control codes on serial as we do over the network. InFocus
network control uses the Telnet packet structure.
IP Address: Identifies the projector on the network.
Subnet Mask: Separates the network address part of the IP address.
Default Gateway: The IP address of the local router.
DNS Server: Shows the address of the DNS server.
DHCP: Select this to automatically obtain an IP address, Subnet mask,
and Default gateway.
AMX DD: When enabled, allows the AMX controller to dynamically
detect the projector.
Network Restart: Disconnects the projector from the network, gets a
new IP address, and reconnects.
Network Info: Provides information on the network configuration.
35
Network
Network Info
Advertisement
Table of Contents
