Trap Settings; Email Settings - HP MicroServe User Manual

Trap Settings

The trap setting configuration screen enables you to specify destination addresses, and
enable/disable SNMP alerts, the event traps can issue an alert if an authentication failure occurs.
Enable-- Enables or disables IPv4/IPV6 destination addresses

IPv4 Destination—Specifies where to send the PET trap from the destinations your defined Note

IPV4 address only support numerical values between 0-255. This field is required only if its
relative checkbox (IPv4 Destination 1, 2, 3 or 4) is checked.
IPV6 Destination—following the instructions of IPv4.

Community String --Displays the SNMP community name


Email Settings

This allows you to enable email alert and specify email address to receive alert message.
Email Alert Number-- Support to set up four email destinations to receive alerts

48