HP Xw4600 - Workstation - 2 GB RAM Installation Manual
Internal usb port kit
Hide thumbs
Also See for Xw4600 - Workstation - 2 GB RAM:
- Technical reference manual (181 pages) ,
- Service and technical reference manual (176 pages) ,
- Specification (73 pages)
Table of Contents
Advertisement
Quick Links
Internal USB port kit installation
Introduction
The internal USB port kit provides a Type A female USB port compatible with Type A USB devices
internal to the computer chassis. This document describes how to install the internal USB port kit on
HP Z and xw series Workstations.
Kit contents
●
Internal USB port kit
●
Adjustable cable strap
●
Warranty information
●
Internal USB port kit installation instructions (this document)
Before you begin
To view QuickSpecs and determine the compatibility of this product with your HP computer, see
http://www.hp.com/go/productbulletin.
ENWW
© 2006–2010 Hewlett-Packard Development Company, L.P. Printed in the U.S.
Introduction
1
Advertisement
Table of Contents
Related Manuals for HP Xw4600 - Workstation - 2 GB RAM
Summary of Contents for HP Xw4600 - Workstation - 2 GB RAM
-
Page 1: Kit Contents
● Internal USB port kit installation instructions (this document) Before you begin To view QuickSpecs and determine the compatibility of this product with your HP computer, see http://www.hp.com/go/productbulletin. © 2006–2010 Hewlett-Packard Development Company, L.P. Printed in the U.S. ENWW Introduction... -
Page 2: Warnings And Cautions
Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce the risk of injury from a hot component, enable the surface to cool before touching. WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. -
Page 3: Step 1-Preparing For Component Installation
Step 1—Preparing for component installation NOTE: Computer models vary. All illustrations are examples only. Accessing the internal components of the computer If you need help preparing the computer for this installation, consult the removal and replacement procedures in the service guide for your computer at http://www.hp.com/support/ manuals. -
Page 4: Step 3-Installing The Internal Usb Cable
Step 3—Installing the internal USB cable Complete the following steps to install the internal USB cable, shown in the following figure. Figure 1 Internal USB cable Attach the internal USB cable 1x5-pin receptacle ( in the preceding figure) to the mating exposed pins of the available 1x5- or 2x5-pin header connector (which ever is available) on the system board: 1x5-pin header. - Page 5 Attach a USB key or other USB device to the Type A receptacle on the other end of the internal USB cable. NOTE: Although the internal USB cable is intended for use with a USB Key, it can be used with any USB device that has a compatible USB Type A male connector.
-
Page 6: Step 4-Reassembling The Computer
Step 4—Reassembling the computer Reinstall the card support, if applicable. Reinstall the side access panel. Reconnect external devices and power cord. Restore power to the computer and all external devices. Japanese 日本語 This document is available in Japanese. See http://www.hp.com/support/manuals, then select your product and select Japanese from the drop down Manual Language menu.