Silo-Type Libraries - HP Data Protector A.06.11 User Manual

Confirmation tab
Mount Listing tab
Dismount Listing tab
Load/Eject Media tab

Silo-type libraries

NOTE:
Run Mount Cycle functionality is not supported for GRAU and DAS devices with this
release.
Assigns scratch media to the specified device in the grid ordering
for the data center. The process also confirms that the media
entered are scratch and of good quality.
To verify the medium, either barcode scan or type a medium
description, and click Verify. To skip the medium, click Skip.
Confirm (by clicking Verify or Skip) all required scratch media
before clicking Mark As Complete.
NOTE:
Click Print Unknown Media to print a list of all unknown,
foreign and blank media.
Poor quality media cannot be used for confirming Scratch
Bin jobs.
Displays devices requiring media, the type and quantity of media.
Displays the media that need to be removed and placed into the
holding bin for manual checking, or for that current day's vaulting
jobs.
Moves the media into/out of the cartridge access port (CAP) for
library devices in the mount/dismount lists.
To run the mount cycle, click Run Mount Cycle (note that this
functionality is not supported for GRAU and DAS devices with
this release). The first time, only a dismount cycle is performed
(which uploads the CAP with the number of media listed on
Premount Job - Dismount Listing). This dismount cycle unloads
from all libraries listed on Premount Job - Load/Eject Media. After
the dismount verification, removed media are marked off. The
second and subsequent cycles involve selecting the libraries from
the list that had their CAPs replaced with scratch media. The
cycle then loads the contents of the CAP, verifies the media
loaded, and ejects any additional dismount media until the CAP
is either full or all dismount media are removed.
User guide 99