Snmp/Insight Manager Settings - HP Integrated Lights-Out User Manual

Subnet Mask
Use the subnet mask parameter to assign the subnet mask for the iLO Diagnostic Port. By default,
o
the subnet mask is 255.255.255.0 for all iLO Diagnostic Ports.
The use of the diagnostic port is automatically sensed when an active network cable is plugged
o
in to it. When switching between the diagnostic and back ports, you must allow 90 seconds for
the network switchover to complete before attempting connection through the Web browser.
NOTE:
firmware update is in progress.
Recovering from a failed iLO firmware update
In the event that an iLO firmware update has failed, there are various recovery options. For all of these
options, you need a current firmware image. HP does not recommended downgrading iLO firmware, and
the version you have could be corrupt.
Download the latest iLO firmware. iLO downloads are available on the HP website
1.
(http://h18004.www1.hp.com/support/files/lights-out/us/index.html).
Determine if the update failed.
2.
Can you ping iLO?
a.
Can you log in?
b.
Does the iLO Option ROM prompt appear during host POST?
c.
Are the iLO status LEDs strobing in a regular pattern? Examine the iLO status LEDs inside the
d.
server to see if they are strobing in a regular pattern from LED 8, 7, 6, 5, 4, 3, 2, 1. If the iLO
LED pattern is visible, proceed to step 4.
Attempt to re-flash over the network.
3.
You might be able to initiate a firmware update using RIBCL or a browser.
If network flash failed, try the on-line flash component. Components are available for both
Windowst® and Linux.
If the on-line flash component failed, try the ROMPAQ diskette.
4.
Build the ROMPAQ diskettes and boot the host using disk 1.
a.
You might need to set the iLO Security Override Switch for ROMPAQ to succeed. Restore the
b.
Security Override Switch after the flash process is complete.

SNMP/Insight Manager settings

The SNMP/Insight Manager Settings option enables you to configure SNMP alerts, generate a test alert,
and configure integration with Systems Insight Manager.
Enabling SNMP alerts
iLO supports up to three IP addresses to receive SNMP alerts. Typically, the addresses used are the same
as the IP address of the Systems Insight Manager server console.
You must have the Configure iLO Settings privilege to change these alert settings. Users that do not have
the Configure iLO Settings privilege can only view the assigned settings.
The following alert options are available in the SNMP/Insight Manager Settings screen:
The diagnostic port will not switch over if an active Remote Console session or a
Configuring iLO 28