HP Integrated Lights-Out User Manual page 49

Click Cancel to close the automated setup wizard. Click Next to set up your blade server. The setup
wizard will guide you through:
iLO configuration
1.
Server RAID verification
2.
Virtual media connection
3.
Software installation
4.
iLO configuration screen
This screen enables you to:
Change the administrator password. HP recommends changing the default password.
Change network configuration settings. The default settings are:
Enable DHCP—Yes
o
Enable Static IP Bay Configuration—No
o
If connected to the blade in enclosure slot 1, you can enable Static IP Bay configuration to
preconfigure the static address for other iLO processors in the enclosure.
In the default configuration, the iLO being updated gets its IP address through DHCP. Other iLO
processors in the enclosure must be configured separately. If these settings are not changed, clicking Next
displays the next page in the setup wizard. If either of these settings are changed, iLO reboots to invoke
the updated settings.
The other configuration combinations are:
Enable DHCP—Yes and Enable Static IP Bay Configuration—Yes
This configuration causes the iLO being configured to get its IP address through DHCP. Clicking Next
displays the Static IP Bay Configuration page, enabling you to specify the IP addresses for other iLOs
in the enclosure. After you click Next, you are prompted to verify that you want to use DHCP for this
iLO IP address.
Enable DHCP—No and Enable Static IP Bay Configuration—Yes
This configuration causes the iLO being configured to set its IP address according to the settings
specified through the Static IP Bay Configuration. Clicking Next displays the Static IP Bay
Configuration page.
Enable DHCP—No and Enable Static IP Bay Configuration—No
This configuration causes the iLO being configured to set its IP address according to the settings
specified through the Network Settings page. Clicking Next displays the Network Settings page.
To save any network changes, you must have the configure iLO privilege.
Configuring iLO 49