HP Integrated Lights-Out User Manual page 27

After completing any parameter changes, click Apply to complete the changes.
4.
When you click Apply, iLO restarts, and your browser connection to iLO terminates. To re-establish a
connection, wait 60 seconds before launching another web browser session and logging in.
For more information, see the HP Integrated Lights-Out Scripting and Command Line Resource Guide.
iLO diagnostic port configuration parameters
The iLO Diagnostic Port on the front of ProLiant BL p-Class servers enables you to access and troubleshoot
server issues by using a diagnostic cable. The iLO Diagnostic Port uses a static IP address. It does not use
DHCP to obtain an IP address, register with WINS or dynamic DNS, or use a gateway. The diagnostic
port cable should not be left plugged in without an active network connection, as it will cause degraded
network performance on the standard iLO network port.
In Network Settings, you can configure specific diagnostic port information. For more information on
using the diagnostic port and the diagnostic cable, refer to the Setup and Installation Guide for the blade
server.
The following are the fields that can be configured for the diagnostic port:
Enable NIC
If Enable NIC is set to Yes, the diagnostic port is enabled.
Transceiver Speed Autoselect
Speed
Duplex
IP Address
Use this parameter to assign a static IP address to iLO on your network. By default, the IP address is
assigned by DHCP. By default, the IP address is 192.168.1.1 for all iLO Diagnostic Ports.
Configuring iLO 27