Browser-Based Setup; Integration With Riloe Ii Accessory Boards - HP Integrated Lights-Out User Manual

To run iLO RBSU:
Restart or power up the server.
1.
Press the F8 key when prompted during POST. The iLO RBSU runs.
2.
If prompted, enter a valid iLO user ID and password with the appropriate iLO privileges (Administer
3.
User Accounts>Configure iLO Settings). Default account information is located on the iLO Default
Network Settings tag attached to the server containing the iLO management processor. If iLO has not
been configured to present a login challenge to the RBSU, no prompt will appear.
Make and save any necessary changes to the iLO configuration.
4.
Exit iLO RBSU.
5.
HP recommends using DNS or DHCP with iLO to simplify installation. If DNS/DHCP cannot be used, use
the following procedure to disable DNS and DHCP and configure the IP address and the subnet mask:
Restart or power up the server.
1.
Press the F8 key when prompted during POST. The iLO RBSU runs.
2.
Enter a valid iLO user ID and password with the appropriate iLO privileges (Administer User
3.
Accounts>Configure iLO Settings). Default account information is located on the iLO Default Network
Settings tag.
Select Network>DNS/DHCP, press the Enter key, and then select DHCP Enable. Press the spacebar to
4.
turn off DHCP. Be sure that DHCP Enable is set to Off, and save the changes.
Select Network>NIC>TCP/IP, press the Enter key, and enter the appropriate information in the IP
5.
Address, Subnet Mask, and Gateway IP Address fields.
Save the changes.
6.
Exit iLO RBSU. The changes take effect when you exit iLO RBSU.
7.

Browser-based setup

Use the browser-based setup method if you can connect to iLO on the network using a browser. You can
also use this method to reconfigure a previously configured iLO.
Access iLO from a remote network client using a supported Web browser, and provide the default
1.
DNS name, user name, and password. Default DNS name and account information is located on the
iLO Network Settings tag attached to the server containing the iLO management processor.
When you successfully log onto iLO, you can change the default values of the network, user, and
SNMP alerting settings through the Web browser interface.
Enter the activation key to enable iLO Advanced features.
2.
If the iLO Advanced features are licensed, you can deploy your operating system using the Virtual
Floppy Drive and install operating system drivers and Insight Manager agents on the remote host
server using the graphical Remote Console.
For ProLiant BL p-Class servers, iLO Advanced functionality is already enabled and cannot be
disabled.

Integration with RILOE II accessory boards

RILOE II is supported as an option in servers with iLO. Previous generations of the Remote Insight boards,
such as the Remote Insight board/PCI and the original RILOE, are not supported in servers with iLO.
Configuring iLO 15