HP NonStop SQL/MX Messages Manual page 465

MXCI Messages (15000 through 15999)
SQL 15554
15554 The operand for name must have a type datatype.
Cause. The operand for the function you specified does not have the correct data
type.
Effect. The operation fails.
Recovery. Change the operand so that it has the specified data type.
SQL 15555
15555 Numeric literal has too many digits. A maximum of 17
digits can be specified with an integral number.
Cause. You specified a numeric literal with too many significant digits, which caused
an arithmetic overflow.
Effect. The operation fails.
Recovery. Correct the literal and recompile.
SQL 15556
15556 Overflow occurred during arithmetic computation.
Cause. An intermediate result was too large to be held in the internal buffers. An
intermediate result overflow can occur because of an arithmetic operation or an
aggregation on large data values.
Effect. The operation fails.
Recovery. For an intermediate result overflow, use simpler arithmetic expressions in
your statements.
SQL 15575
15575 column-ID is not specified in a current command-name
command and cannot be reset.
Cause. The column ID displayed was specified in a RESET REPORT command.
However, that column ID is not currently set by the corresponding report command.
Effect. The column ID is ignored by the RESET REPORT command.
Recovery. This is an informational message; no recovery is necessary.
HP NonStop SQL/MX Messages Manual—640324-001
15 -77