Table of Contents
Advertisement
MXCI Messages (15000 through 15999)
Recovery. Enter a BREAK command or delete the SUBTOTAL command by using
RESET.
SQL 15522
15522 Because of the new report definition command(s), the
report is being regenerated from the start.
Cause. A BREAK, SUBTOTAL, or TOTAL command was specified after some rows
were listed, and then a LIST NEXT command was specified, as in the following
sequence: SELECT; LIST FIRST n; BREAK ON...;LIST NEXT n.
Effect. Instead of listing the next n rows, the report is started over from the first row.
Recovery. Informational message only; no corrective action is needed.
SQL 15523
15523 The value of SPACE is out of range. The valid range is
0 through 255.
Cause. The value that you specified for the SPACE option was not in the range 0
through 255.
Effect. The DETAIL command fails.
Recovery. Correct the value of SPACE and resubmit.
SQL 15524
15524 The value of TAB is out of range. The valid range is
the set of values from left margin to right margin.
Cause. The value that you specified for the TAB clause was less than the left margin
or greater than the right margin.
Effect. The DETAIL command fails.
Recovery. Correct the value of TAB and resubmit.
SQL 15525
15525 The value for PAGE, NEED, or SKIP is out of range. The
valid range is 1 through 32767.
Cause. The value that you specified for the PAGE, NEED, or SKIP clause was not in
the range 1 through 32767.
Effect. The DETAIL command fails.
HP NonStop SQL/MX Messages Manual—640324-001
15 -69
Hide quick links:
Advertisement
Table of Contents
