HP NonStop SQL/MX Messages Manual page 439

MXCI Messages (15000 through 15999)
SQL 15390
15390 Initial server count int1 exceeds maximum server count
int2 (or 200, whichever is smaller) for DS string1.
Where int1 is the initial server count specified in the command.
Where int2 is the maximum server count for the data source specified in the
command.
Where string1 is the data source name.
Cause. Initial server count is too large.
Effect. The operation fails.
Recovery. Either increase the maximum server count or decrease the initial server
count of the data source.
SQL 15391
15391 Could not start DS string1.
reason is that SERVICE is in the stopped state. Use INFO
SERVICE to check the SERVICE state.
Where string1 is the data source name.
Cause. A failure occurs in the client library.
Effect. The operation fails.
Recovery. See the lower-level error messages that follow this message.
SQL 15392
15392 Could not stop DS string1.
Where string1 is the data source name.
Cause. A failure occurs in the client library.
Effect. The operation fails.
Recovery. See the lower-level error messages that follow this message.
HP NonStop SQL/MX Messages Manual—640324-001
+++SUGG: Most likely
15 -51