HP NonStop SQL/MX Messages Manual page 430

MXCI Messages (15000 through 15999)
SQL 15355
15355 Could not get name of next DS on the SERVICE service-
name.
Where service-name is the name of the service.
Cause. The lower-level fails to return the next data source name on the service. The
system might be busy.
Effect. The operation fails.
Recovery. Use the INFO SERVICE * command to verify that the service exists, then
retry the failed command. See the lower-level error messages issued with this
message.
SQL 15356
15356 Failed in scan of SERVERs on the SERVICE service-name
before finding target name, count were skipped before
failure.
Where service-name is the name of the service.
Where count is the number of servers scanned on the service.
Cause. The lower level fails to return data from scanning the list of servers or a
specific server is not found on the service. The number of servers scanned is output.
The system might be busy.
Effect. The operation fails.
Recovery. Run the INFO SERVICE * command to verify that the service exists, and
then retry the failed command. See the lower-level error messages issued with this
message.
SQL 15357
15357 SERVER server-name was not found, looked at count.
+++SUGG: Perhaps name is not valid or it already terminated.
Where server-name is the name of the server.
Where count is the number of servers scanned.
Cause. A specific server is not found. The number of servers scanned is output.
Effect. The operation fails.
Recovery. Check the spelling of the server name and verify that it is a valid name.
Enter the command with the correct server name. If the error persists, verify that the
server is operational.
HP NonStop SQL/MX Messages Manual—640324-001
15 -42