Installation; Control Panel - Haier HD80-01-U User Manual

6 E B O F

INSTALLATION

BASIC INSTRUCTIONS
To ensure the tumble dryer operates normally, y y attention must
be paid to the following instructions:
¬ The tumble dryer must be level when installed. It's bot-
tom is equipped with adjustable feet. Adjust these 4 feet
to level the device before operation.
¬ Check whether any damage occurred to the tumble dryer
during transportation. A damaged tumble dryer must not
be used. If the device is damaged, contact your supplier.
¬
substances.
¬ The surrounding environment must be dry and ventilated.
¬ To allow the tumble dryer to perform better, r the ambient
temperature shall not be lower than 10 °C nor higher than
35 °C.
DRAIN SWITCHOVER
During the drying of the laundry, y y the condensate water is
automatically collected in the water collection tank inside the
tumble dyer, r r so that the water needs to be removed from
the tank after every drying cycle. If your tumble dryer is in
the vicinity of a drain, you may allow the condensed water
to discharge directly into the drain through the drainpipe
provided to avoid emptying the tank every time.
The method to connect the drainpipe is as follows:
1. Draw the drainpipe from the joint.
2. Insert the drainpipe on the fixture.
3. Take out the accessory drainpipe.
4. Fix the drainpipe at the place of the joint.
Note: The outlet of the drainpipe must not be p
CONNECTING TO THE POWER SUPPLY L L
Before connecting to the power supply, y check:
¬ The socket is adequate for the maximum power of the
tumble dryer (For safety, y y fuses in the power circuit should
be rated for no less than 15A).
¬ The voltage should meet the requirement.
¬ The power outlet should be capable of accepting the
tumble dryer plug.
¬ Connect the device to an earthed socket outlet.
E R U E S
1
2.
3.
4 4 . .
E B

CONTROL PANEL

Power button E Anti-crease button
B Program knob F Delicate button
C Start/ t t Pause button G Delay button
D Signal button H Maintenance displays
OPERATIONAL FUNCTIONS
_ Press this button to turn the tumble dryer on and off.
A ¬ Power button
_ Turn this knob to choose the desired drying program. This type of tumble dryer has 10
B ¬ Program knob
9. When the drying program is selected, the relevant indicator light is on.
_ Press this button to start the tumble dryer. Press this button again during the operation of
C ¬ Start/ t t Pause button
dyer will pause. Press the button again and the program will continue.
_
D
¬ Signal button
button to cancel the buzzer sound.
_ If this additional function is selected, the anti-crease phase at the end of the drying cycle is
E
¬ Anti-crease button
lengthened by 60 minutes. The laundry can be removed at any time during the anti-crease
phase.
_ During a program, the drying temperature and power will decrease and the drying time will
F ¬ Delicate button
increase to take better care of the delicate laundry.
O F E R U E S
I
H J
30min Very dry
Time
20min
Damp
Damp
Normal
Clean
filter
Cotton
Normal
Very dry
Start/pause
Delay Delicate Long Anti-crease Signal
G F E D C B
I Display
J Maintenance displays
7
Synthetic
Power
Wool
Cool
A