Haier HD80-01-U User Manual page 3

4 E B O F
R P P E R A I T A N O
PREPA P P RING THE TUMBLE DRYER
Remove all the packing materials to prevent unsteadiness, including the polystyrene
base.
DESCRIPTION
Control panel
Tumble dryer door
Water collection tank
Service door for condenser
This diagram may be slightly different from the layout of the tumble dryer you have
just purchased due to technical improvements.
E R U E S
Drainage outlet
Back plate
Power cord
Screw foot
Synthetic
Power
E B
A S E F Y T S N I R T C U O I T S N
BEFORE SWITCHING THE DEVICE ON FOR THE FIRST TIME
DO ...
... ensure that the device is installed and electrically
to local codes to prevent shock hazard and assure
stability during operation.
... install this tumble dryer properly in accordance with
the installation instructions before use.
... keep surrounding areas free from accumulation of
lint, t t dust and dirt.
... use a separate earthed socket for the power supply.
... ensure that the electrical system meets the require-
ments laid out in the installation part of this manual.
DURING DAILY L L USE OF THE DEVICE
DO ...
... wait until the tumble dryer has stopped completely
before reaching into the drum to prevent injury. Never
reach into the tumble dryer when the drum is moving.
... clean lint screen before or after each load.
... remove the tumble dryer door to prevent accidental
entrapment before the device is removed from service.
... unplug the device before carrying out any main-
tenance or repair. Hold the plug and not the electric
cable when unplugging the power supply.
... wash items that have been soiled with substances
such as cooking oil, acetone, alcohol, petrol, kerosene,
spot removers, turpentine, waxes and wax removers
in hot water with an extra amount of detergent before
being dried in the tumble dryer.
... ensure that the device is not used by persons with
reduced physical, sensory or mental capabilities, lack
of experience and knowledge without supervision or
instruction by a person responsible for their safety.
... supervise children to ensure that they do not play
with the device.
O F E R U E S
DO NOT ...
... install or store this device outdoors in a damp place,
or in an area which may be prone to water leaks such
as under or near a sink unit. In the event of a water
leak allow the device to dry naturally.
... operate the tumble dryer if any parts are missing
or broken.
and liquids in the vicinity to the device.
... use an adaptor plug or extension cord.
... connect the device to the power supply until instal-
lation is complete.
... repair or replace any part of the appliance or
in the user-maintenance instructions or in published
user-repair instructions that you understand and have
skills to carry out.
DO NOT ...
... sit on top of the tumble dryer.
... tamper with controls.
... dry unwashed items in the tumble dryer.
... dry items such as foam rubber (latex foam), shower
caps, waterproof textiles, rubber backed articles and
... dry items that have been previously cleaned in,
washed in, soaked in, or spotted with gasoline,
cleaning solvents, kerosene, waxes, etc. Do not store
these items spotted with gasoline, cleaning solvents,
kerosene, waxes, etc. on or near the tumble dryer.
These substances give off vapours that could ignite or
explode.
... use heat to dry items containing plastic, foam, rub-
ber or similarly textured rubber-like materials or items
... stop a tumble dryer before the end of the drying
cycle unless all items are quickly removed and spread
out so that the heat is dissipated.
5