Stacking Instructions; Tools Needed; Installation Preparation - Haier GE GFD14ESSNWW Technical Service Manual

24 inch vented dryer

Hide thumbs

Table Of Contents

Table of Contents

The GE Appliances 24-Inch Dryer is designed

to be placed on top (stacking) of certain 24-Inch

washers. Washer models that currently qualify

for stacking are:

• GFW148

NOTE: If planning to stack the washer and dryer,

order Stacking Kit (Part #: GFA24KITL) to be

used on this dryer. The kit is sold separately.

WARNING!

• Make sure that the dryer is unplugged.

• Two people are recommended to safely lift the

dryer into and out of position.

• Avoid damage to the existing utility services.

Location Requirements

When installed in a location other than an alcove

or closet, the minimal clearances to combustible

surfaces and for air opening are:

• 1-inch on both sides

• 3-inches' front and rear

• 1-inch on top

Consideration must be given to provide adequate

clearance for installation and service.

NOTE: If the dryer is approved for installation in

an alcove or a closet, it will be stated on a label

on the back.

When installed in an alcove or closet:

• The dryer MUST be vented to the outdoors.

• Minimum clearance between the dryer

cabinet and the adjacent walls or other

surfaces is 0 inches' either side, and 3 inches'

front and rear.

• Minimum vertical space from floor to

overhead shelves, cabinets, ceilings, etc., is

67.7 inches.

• Closet doors must be louvered or otherwise

ventilated and have at least 60 square inches

of open area equally distributed. If the closet

contains both a washer and a dryer, the

doors must contain a minimum of 120 square

inches of open area equally distributed.