Advertisement
Maintenance, Cleaning and Disposal
- Keep the gasket, dispenser and door clean to prevent odours.
- Do not use water spray or steam to clean the appliance.
- A damaged electrical cable must be replaced by a Haier service technician or
similarly qualified person. Do not use the appliance until it has been repaired to
avoid a risk of electric shock.
- The only user-removable parts of the appliance are the lint filter and the
condenser filter. No other parts are designed to be removed by the user.
- When disposing of the appliance, it is recommended that the door is removed
to avoid children getting trapped inside, and that the electrical cable is cut off
close to the machine.
- Unless the product is modified by an approved technician, any changes might
result in loss of warranty.
Installation
WARNING! Electric Shock Hazard Failure to follow this advice may result
in electric shock or death.
- Ensure that the appliance cable is positioned so that it does not come into
contact with water or moisture.
- The appliance must not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly switched on and off
by a utility.
- Install the appliance in a well-ventilated, dust-free environment.
- This appliance must not be installed or operated on a plinth (other than a
genuine Haier part, installed per the instructions).
- We do not recommend the use of extension cords or portable electrical
outlet devices.
- Ensure the installation provides accessibility to the plug or incorporate a
switch in the fixed wiring in accordance with the wiring rules to allow
disconnection of the appliance from the supply after installation.
- Review the electrical information on the rating plate before plugging in this
appliance to make sure the right voltage and current can be supplied.
- Install the appliance on a solid and level surface ensuring it has 20mm
clearance on each side. The appliance must not be installed on any textured
floor coverings (eg carpet, rugs).
- We recommend to replace the inlet hoses (if any) every 5 years.
Advertisement
