Display Codes & Troubleshooting - Haier HD80-01-U User Manual

16 M I A
CLEANING & CARE
CLEANING THE DRUM
After the tumble dryer has operated for a time, fabric caring
agents or calcium contained in the water will form an almost
invisible layer on the inside of the drum.
CLEANING THE CONDENSER
The condenser must be cleaned monthly. Switch off the power
supply and remove the plug before cleaning:
1. Unlock the maintenance flap and open it.
2. Screw both locking levers towards each other,Pull out the
handle/air cooler.
3. Thoroughly clean the handle/air cooler,allow all the
water to drip out,then clean the seals.
4. Re-insert the handle/air cooler,handle below,
unscrew both locking levers,close the maintenance flap
until it locks into position.
Note: Do not use a sharp tool cleaning the
heat exchanger, otherwise it may damage its
sealing performance.
T N N E A N E C
1.
3.
DISPLAY CODES & TROUBLESHOOTING
DISPLAY CODES
C D O S E A C S U S E
F2 ¬ Drain pump error.
F3 ¬ The thermal sensor(near the filter) is open-circuited or
short-circuited.
¬ Temperature of the laundry in the drum does not change.
F4
¬ The filter is full.
F6
¬ The thermal sensor(near the heater) is open-circuited or
F9
short-circuited.
TROUBLESHOOTING
P O R L B M E A C S U
2.
Tumble dryer fails to ¬ Poor connection to the power supply.
operate. ¬ Power failure.
¬ No drying program is set.
¬ Device has not been switched on.
¬ The water collection tank is full.
¬ The tumble dryer door is not properly closed.
Tumble dryer fails to oper-
4.
ate and the display shows by the program setting.
"End". ¬ There is no laundry in the drum.
Drying time is too long
¬ The program setting is not correct.
and the results are not
satisfactory. ¬ The condenser is blocked.
¬ The tumble dryer is overloaded.
¬ The laundry is too wet.
¬ The vent duct is blocked.
Remaining time on the The remaining time will be adjusted and
display stops or skips. corrected continuously and automatically based
upon the following factors:
¬ Type of laundry.
¬ Loaded amount.
¬ The degree of spinning dry of laundry.
¬ Ambient temperature.
M I A T N N E A N E C
O S U L O I T S N
_ Please contact the service center.
_ Please contact the service center.
_ Please contact the service center.
_ Clean the filter.
_ Please contact the service center.
S E O S U L O I T S N
_ Check connection to the power supply.
_ Check the power supply.
_ Make sure a drying program has been set.
_ Make sure the device is switched on.
_ Empty the water collection tank.
_ Close the tumble dryer door properly.
_ Check if your program setting is appropriate.
_ Check if there's laundry in the drum.
_ Make sure the program is set correctly.
_
_ Clean the condenser.
_ Reduce the amount ofl aundry in the drum.
_ Spin the laundry properly before drying.
_ Check the vent duct and unblock it.
_ The automatic adjustment is a normal
operation.
17