Installation - Haier HDHP80AN1 User Manual

13-Installation

Freestanding & Stacking
Your dryer can be installed one of two ways, either freestanding, or stacked on top of a Haier front
loading washer.
1. The dryer stands on the floor and can easily be moved into position.
2. Your dryer has been designed to be able to be stacked on top of a Haier front loading washer.
A stacking kit MUST BE USED between the products and fitted correctly to the washing machine
and dryer, as per the stacking kit instructions.
Reversing the door swing
These instructions are for changing the hinges from the right side to the left side.
If you ever want to switch them back to the right side, follow these same instructions
and reverse all references to the left and right.
1. Remove the door assembly
Open the door. Remove the two screws holding the-
hinge/door assembly to the dryer. Carefully set the hinge/
door assembly aside (Fig. 13-1).
2. Remove, rotate and replace the inner door
Remove the eight stickers and screws securing the inner
door to the outer door. Remove the inner door, rotate it
180° and reinstall it into the outer door using the same
eight screws and stickers (Fig. 13-2).
3. Remove, rotate and replace the door lock & strike plate
Remove the two screws holding the strike plate, and then
remove one screw of the door lock, push down and take out
the lock rotated 180° and install it on the opposite side. the
same eight screws and stickers (Fig. 13-3).
4. Rotate and replace the hinge/door assembly
Rotate the hinge/door assembly and secure with same two
screws on the hinge/door assembly to the dryer. (Fig. 13-4).
26
Hinge and Door
Hold the Door and
Remove Hinge Screws
from the Dryer
Remove the
Remove eight
inner door with
Inner door and
stickers and
o eight screws and
ro rotated 180
screws
stickers
as shown
Strike Plate
and Screws
1.Push
down
2.rotate an
angle then
can take
out
NZ AU
13-1
Assembly
13-2
Replace the
Replace
the Door lock
and then
Reinstall
Strike Plate
and Screws
13-3
Secure with same
two screws
13-4