Table of Contents
Advertisement
Monitored Reversing Devices
CAL
CAL
Safe-T-Beams® (OPTIONAL)
1) If operator is in RUN mode, press CAL/RUN
2) Press SCROLL
(up or down) until display reads "ODC STB>ON" or
CROL
"ODC STB>OFF" Figure 15.
3) Press SET/CLEAR
key to toggle between ON and OFF.
SET
CLEAR
4) Press SCROLL
(up or down) to shift to a new function and lock setting.
SCROLL
5) Press CAL/RUN
to return to run mode.
CAL
RUN
WARNING
entrapment protection when mounted near the doorway
in such a way that the lower portion of an individuals leg
will break the photocell beam during normal walking
through the doorway. If an alternative mounting location
is chosen, it must be approved by the facility owner.
Current UL Approved Monitored Reversing Devices
1) MillerEdge ME and MT series monitored edge sensors used in
combination with Timer-Close Module P/N OPABTCX.S.
2) MillerEdge ME and MT series monitored edge sensors used in
combination with MillerEdge Signature Module SM-101. (Direct
connect through STB inputs).
3) FRABA OptoEdge OSE-S-5010 series monitored edge sensors used in
combination with Timer-Close Module P/N OPABTCX.S.
4) FRABA OptoEdge OSE-S-5010 series monitored edge sensors used in
combination with MillerEdge Signature Module SM-101. (Direct
connect through STB inputs).
5) Residential Safe-T-Beam® Monitored Photocells from The Genie® Company,
model OSTB-BX (P/N 37221R).
6) Series II Safe-T-Beam® Monitored Photocells (P/N 37221R and OPAKPE.S).
7) FRABA OptoEye OSE-S-5000, Monitored Photocells P/N OPAKPEN4.S and OPAKPEN4GX.S.
GCL-GT
Heavy Duty Operator
to enter calibration mode.
CAL
RUN
Photocell systems provide
:
www.geniecompany.com
NOTE: Installation of Series II Monitored Photocells DOES NOT make the GT™
unit legal for residential use. The Genie® Company strictly prohibits any
installation of a commercial unit in any residentially zoned construction.
CAL
RUN
OPEN
ODC STB ON
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
Figure 15
03-12
6.9
Advertisement
Table of Contents
