Important Safety Instructions - Genie GPS-IC Series Owner's Manual

MA A IN N TE E N A A N N C C E E
DOOR SPRINGS and DOOR HARDWARE
Do not operate garage door automatically or
•
manually if springs are broken. CONTACT A
PROFESSIONAL FOR SERVICE.
Oil door rollers, bearings, and hinges monthly.
•
Use silicone lubricant or light oil.
DOOR BALANCE
Close door. Pull red emergency release knob
•
down and toward power head to release door
from rail assembly.
Raise door manually approximately 3 feet. Door
•
should stay in that position. If door moves, HAVE
DOOR SERVICED BY A PROFESSIONAL.
Close door. Pull red emergency release knob to
•
reattach door to rail/channel assembly.
IMPORTANT
SAFETY INSTRUCTIONS
WARNING
Toreduce the risk of
severe injury or death:
1 READ AND FOLLOW ALL INSTRUCTIONS.
2 Never let children operate or play with the Door
Controls. Keep the Remote Control away
from children.
3 Always keep the moving door in sight and away
from people and objects until the door is completely
closed. NO ONE SHOULD CROSS THE PATH OF
THE MOVING DOOR.
4 NEVER GO UNDER A STOPPED, PARTIALLY
OPEN DOOR.
5 Test Opener monthly. The door MUST reverse on
contact with a 1-1/2" high object (or a 2" x 4" board
laid flat) at the center of the doorway on the floor.
After adjusting either the Force or the Limit of travel,
retest the Door Opener. Failure to adjust the
Opener properly may cause severe injury or death.
6 When possible use the Emergency Release only
when the door is closed. Use caution when using
this Release with the door open. Weak or broken
springs are capable of increasing the rate of door
closure and increasing the risk of severe injury
or death.
7 KEEP GARAGE DOORS PROPERLY BALANCED.
See Owner's Manual. An improperly balanced door
increases the risk of severe injury or death. Have a
Genie Factory Authorized Dealer make repairs to
cables, spring assemblies, and other hardware.
SAVE THESE INSTRUCTIONS .
8
M M M M O O N N T T H H L L Y Y M M A A A A I I I N N N T T E E E N N N N A A A A N N C C E E
CONTACT REVERSE
Close door on a 2 by 4 board laid flat on the floor
•
in the center of the garage doorway.
Close door by using wall button or remote control.
•
If door fails to reverse on contact with the board,
•
see Section 7- CONTACT REVERSE.
If operator still fails, replace operator or HAVE
•
THE DOOR SERVICED BY A PROFESSIONAL.
Safe-T-Beam
Use self-diagnostic Safe-T-Beam
•
troubleshooting information to maintain safe
operation.
(See Section 3- STB SYSTEM INSTALLATION.)
FO O R H H EL L P P - - 1.800 0 .3 3 54.364 4 3 O O R G G ENIECOMPANY.COM
STB SYSTEM
®
Transmitter Compliance Statement
27
System
®