Genie IntelliG 850 Quick Reference Card

Setting Limits & Remote Programming for
For detailed instructions refer to owner's manual. 800-35-GENIE.
WARNING: DO NOT use wall console until limits have been set.
WARNING: Bullet MUST be engaged to carriage BEFORE setting limits.
Setting Down Limits:
2
Press and hold the down arrow button (-) for
2 seconds until the long LED comes on blue
(round LED remains off).
PROGRAM
–
SET
HOLD HOLD
2 seconds 2 seconds
3
Release down arrow button (-) and the long LED
will begin flashing.
PROGRAM
SET
4
Press and hold the down arrow button (-) until
garage door is fully closed on floor, then release.
PROGRAM
SET
PROGRAM
SET
5
Press and release the Program Set button (both
LEDs flash blue and go off).
PROGRAM
–
SET
The down limit is now set.
IntelliG , TriloG
®
ReliaG 850 & 650 Models
®
PROGRAM
+
SET
–
+
– +
HOLD
– +
PROGRAM
+
SET
Quick Reference Card for
Setting Limits & Remote
Programming
, GPower
®
Setting Up Limits:
6
Press and hold the up arrow button (+) for
2 seconds until the long LED light comes on blue
(round LED remains off).
PROGRAM
SET
7
Release up arrow button (+) and the round LED
will begin flashing.
8
Press and hold the up arrow button (+) until door
is fully open, then release. Watch carriage as
it approaches the powerhead to avoid contact
with powerhead.
9
Press and release the Program Set button (both
LEDs flash blue and go off).
PROGRAM
SET
The up limit is now set.
If both LEDs turn RED at this time, return
to Step 1, Setting Down Limits.
&
®
– +
HOLD HOLD
2 seconds 2 seconds
PROGRAM
–
+
SET
PROGRAM
– +
SET
HOLD
PROGRAM
+
–
SET
– +
PROGRAM
SET
PROGRAM
SET