Table of Contents
Advertisement
NAME OF PARTS
Display
1
3
2
4
5
A
C
1 MODE button
2 ECONOMY button
3 SET TEMP. button (
4 FILTER RESET button
5 SLEEP button
6 FAN button
7 START/STOP button
8 SET button (Vertical)
9 SET button (Horizontal)
0 SWING button
A TIMER MODE button
B TIMER SET (
/
C CLOCK ADJUST button
D RESET button
E TEST RUN button
● This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air condition-
er's thermostat function to operate incorrectly.
● If this button is pressed during normal opera-
tion, the unit will switch to test operation
mode, and the Indoor Unit's OPERATION In-
dicator Lamp and TIMER Indicator Lamp will
begin to flash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
F
6
7
8
9
0
D
B
E
/
)
) button
Display panel
G
H
I
J
To facilitate explanation, the accompanying illustration
has been drawn to show all possible indicators; in ac-
tual operation, however, the display will only show those
indicators appropriate to the current operation.
F Signal Transmitter
G Temperature SET Display
H ECONOMY Display
I Operating Mode Display
J SLEEP Display
K Transmit Indicator
L Fan Speed Display
M SWING Display
N Timer Mode Display
O Clock Display
Some indoor units may not be equipped with the func-
tions corresponding to all of the buttons on this remote
controller. The indoor unit will beep and the OPERATION,
TIMER and FILTER lamp flash when a remote controller
button is pressed if the function is not available.
K
L
M
N
O
En-2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote Control and is the answer not in the manual?
Questions and answers
The remote control just has the time display after I change the battery. I have tried to reset it but nothing was working
After changing the battery, the Fujitsu remote control may only display the time because it needs to be reset. To reset it, follow these steps:
1. Press the CLOCK ADJUST button using the tip of a ballpoint pen or a small object.
2. Use the TIMER SET (▲/▼) buttons to adjust the clock to the current time.
- ▲ Button: Advances the time.
- ▼ Button: Reverses the time.
- Holding the buttons speeds up the adjustment in ten-minute increments.
3. Press the CLOCK ADJUST button again to complete the setting and start the clock.
If the remote control is still not functioning properly, press the RESET button with a ballpoint pen tip. If issues persist, check the battery installation or replace the batteries.
This answer is automatically generated