Table of Contents
Advertisement
CONTENTS
SAFETY PRECAUTIONS ................................................ 1
NAME OF PARTS ........................................................... 2
PREPARATION ............................................................... 3
OPERATION ................................................................... 4
TIMER OPERATION ....................................................... 6
SLEEP TIMER OPERATION ........................................... 7
FILTER LAMP RESET ..................................................... 7
SAFETY PRECAUTIONS
● Before using the appliance, read these "SAFETY PRECAUTIONS" thoroughly and operate in the correct way.
● The instructions in this section all relate to safety; be sure to maintain safe operating conditions.
This mark indicates procedures which, if improperly performed, might lead to the death or serious
WAERNING!
injury of the user.
• If a problem (burning smell, etc.) occurs, turn off the electrical breaker immediately to stop operation, and then consult
authorized service personnel.
This mark indicates procedures which, if improperly performed, might possibly result in personal harm
CAUTION!
to the user, or damage to property.
• Do not expose the controller directly to water.
• Do not operate the controller with wet hands.
• Do not touch the switches with sharp objects.
• Always turn off the electrical breaker whenever clean-
ing the controller, the air conditioner or the air filter.
En-1
AIR CIRCULATION ......................................................... 8
SWING OPERATION ...................................................... 9
ECONOMY OPERATION ................................................ 9
SIGNAL CODE .............................................................. 10
TROUBLESHOOTING .................................................. 11
• Ensure that any electronic equipment is at least one
metre away from the controller.
• Avoid installing the controller near a fireplace or other
heating apparatus.
• Do not use inflammable gases near the controller.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote Control and is the answer not in the manual?
Questions and answers
The remote control just has the time display after I change the battery. I have tried to reset it but nothing was working
After changing the battery, the Fujitsu remote control may only display the time because it needs to be reset. To reset it, follow these steps:
1. Press the CLOCK ADJUST button using the tip of a ballpoint pen or a small object.
2. Use the TIMER SET (▲/▼) buttons to adjust the clock to the current time.
- ▲ Button: Advances the time.
- ▼ Button: Reverses the time.
- Holding the buttons speeds up the adjustment in ten-minute increments.
3. Press the CLOCK ADJUST button again to complete the setting and start the clock.
If the remote control is still not functioning properly, press the RESET button with a ballpoint pen tip. If issues persist, check the battery installation or replace the batteries.
This answer is automatically generated