Table of Contents
Advertisement
SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE
When two or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other
than the one you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to
set (four selections possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner
signal codes.
Selecting the Remote Control Unit Signal Code
Use the following steps to select the signal code of the remote control unit. (Note
that the air conditioner cannot receive a signal code if the air conditioner has not
been set for the signal code.)
1
Press the START/STOP button until only the clock is
displayed on the remote control unit display.
2
Press the MODE button for at least five seconds to dis-
play the current signal code (initially set to ).
3
Press the
tween
air conditioner signal code.
4
Press the MODE button again to return to the clock
display. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.
The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a
signal code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
code which operates the air conditioner.
buttons to change the signal code be-
. Match the code on the display to the
) until you find the
En-10
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote Control and is the answer not in the manual?
Questions and answers
The remote control just has the time display after I change the battery. I have tried to reset it but nothing was working
After changing the battery, the Fujitsu remote control may only display the time because it needs to be reset. To reset it, follow these steps:
1. Press the CLOCK ADJUST button using the tip of a ballpoint pen or a small object.
2. Use the TIMER SET (▲/▼) buttons to adjust the clock to the current time.
- ▲ Button: Advances the time.
- ▼ Button: Reverses the time.
- Holding the buttons speeds up the adjustment in ten-minute increments.
3. Press the CLOCK ADJUST button again to complete the setting and start the clock.
If the remote control is still not functioning properly, press the RESET button with a ballpoint pen tip. If issues persist, check the battery installation or replace the batteries.
This answer is automatically generated