Table of Contents
Advertisement
SWING OPERATION
Left/right and up/down/left/right swing operation cannot be performed on models that are not equipped with horizontal air-
flow louvers.
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button.
Each time the SWING button is pressed, the swing operation will change in the
following order.
Up/down swing operation
Swing operation stops
To stop SWING Operation
Press the SWING button and select STOP.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
● Left/right swing: The airflow-direction louvers move (swing) in the left/right airflow direction.
● Up/down/left/right swing: The airflow-direction louvers move (swing) in both the up/down and left/right airflow directions.
● The SWING operation may stop temporarily when the air conditioner's fan is not operating, or when operating at very low
speeds.
● If the SET button (Vertical) is pressed during the up/down swing operation, the up/down swing operation will stop and if the
SET button (Horizontal) is pressed during the left/right swing operation, the left/right swing operation will stop.
● The swing operation is not available depending on the model. Please refer to the MANUAL (OPERATING) which is included
in INDOOR UNIT.
ECONOMY OPERATION
Begin Air Conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button.
"ECO" appears on the Remote Control Unit display.
Economy operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button again.
"ECO" disappears from the Remote Control Unit display.
Normal operation begins.
About ECONOMY Operation
At the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation for cooling and
heating.
When ECONOMY operation is performed during the cooling mode, dehumidification is improved. This function is especially
convenient when you want to remove the humidity in the room without significantly lowering the room temperature.
During ECONOMY operation, the thermostat setting automatically changes according to the temperature to avoid Unneces-
sary cooling and heating for the most economical operation.
● If the room is not cooled (or heated) well during economy operation, select normal operation.
● Once air conditioner operation is stopped, normal operation begins when the indoor unit is turned on again.
● During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if
ECONOMY operation is selected by pressing the ECONOMY operation button.
En-9
Left/right swing operation
Up/down/left/right swing operation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Remote Control and is the answer not in the manual?
Questions and answers
The remote control just has the time display after I change the battery. I have tried to reset it but nothing was working
After changing the battery, the Fujitsu remote control may only display the time because it needs to be reset. To reset it, follow these steps:
1. Press the CLOCK ADJUST button using the tip of a ballpoint pen or a small object.
2. Use the TIMER SET (▲/▼) buttons to adjust the clock to the current time.
- ▲ Button: Advances the time.
- ▼ Button: Reverses the time.
- Holding the buttons speeds up the adjustment in ten-minute increments.
3. Press the CLOCK ADJUST button again to complete the setting and start the clock.
If the remote control is still not functioning properly, press the RESET button with a ballpoint pen tip. If issues persist, check the battery installation or replace the batteries.
This answer is automatically generated