Name Of Parts - Fujitsu UTY-LNHUM Operating Manual

NAME OF PARTS

Display
1
2
3
4
5
11
13
1 "MODE" button
2 "SET TEMP. (
3 "MIN.HEAT" button
4 "ECONOMY" button
5 "SLEEP" button
6 "FAN" button
7 "START/STOP" button
8 " SET" button (Vertical)
9 " SET" button (Horizontal)
0 " SWING" button
A "TIMER MODE" button
B "TIMER SET (
C "CLOCK ADJUST" button
D "RESET" button
E "TEST RUN" button
● This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air conditioner's
temperature function to operate incorrectly.
● If this button is pressed during normal operation,
the unit will switch to test operation mode, and
the Indoor Unit's OPERATION Indicator Lamp
and TIMER Indicator Lamp will begin to fl ash
simultaneously.
● To stop the test operation mode, press the
"START/STOP" button to stop the air condi-
tioner.
En-3
16
6
7
8
9
10
14
12
15
/ )" button
/ )" button
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual opera-
tion, however, the display will only show those indicators
appropriate to the current operation.
F Signal Transmitter
G Temperature SET Display
H Operation Mode Display
I SLEEP Display
J Transmit Indicator
K Fan Speed Display
L SWING Display
M T imer Mode Display
N Clock Display
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and FILTER lamp fl ash when a remote controller button is
pressed if the function is not available.
21
22
23
24