Figure 5. Removing Front And Rear Supports - Powerware 9350 Installation Manual

LEFT HAND
DOOR
(Step 1)
2
1
FLOOR
PROTECTOR
(Step 2)
3
. Loosen, but do not remove, the hardware holding the foam cushions to the front
and rear supports (labeled "1" in Figure 5).
BATTERY CABINETS ARE EXTREMELY HEAVY. IF UNLOADING INSTRUCTIONS
4
. Turn each jacking bolt consecutively, two full turns, until the foam cushions clear
the floor by approximately 3 mm (1/8 in.).
TURNING THE JACKING BOLTS UNEVENLY MAY CAUSE THE CABINET TO
BECOME UNBALANCED. TO PREVENT TIPPING THE CABINET, RAISE AND
THE BATTERY CABINET SHOULD ONLY BE RAISED APPROXIMATELY 3 mm
(1/8 in.) ABOVE THE FLOOR (JUST ENOUGH TO ALLOW REMOVAL OF THE
5
. After the foam cushions clear the floor, remove the hardware loosened in Step 3.
Pull the foam cushions out from under the battery cabinet. Please discard or
recycle them in a responsible manner.
8
FRONT
SUPPORT
2
2
1
(Step 3)

Figure 5. Removing Front and Rear Supports

WARNING: SERIOUS INJURY MAY OCCUR!
ARE NOT CLOSELY FOLLOWED, CABINET MAY TIP .
DANGER: RISK OF INSTABILITY!
LOWER THE JACKING BOLTS EVENLY.
DANGER: CABINET MAY TIP!
FOAM CUSHIONS).
Powerware 9350 Series 685 and 1085 Auxiliary Battery Cabinets
SIDE
SUPPORT
JACKING
2 (Step 2)
(Step 8)
Installation Manual 164201408 Rev. P00 053002
FOAM
CUSHION
2
1
BOLT