Sampled Audio For Sound Effects <Saf - Polycom SIP 2.2.2 Manual

Attribute
tone.chord.cat.x.freq.y
tone.chord.cat.x.level.y
tone.chord.cat.x.onDur
tone.chord.cat.x.offDur
tone.chord.cat.x.repeat
Sampled Audio for Sound Effects <saf/>
Note
In the following table, x is the chord-set number and cat is one of callProg,
ringer, or misc.
Permitted
Values
0-1600
-57 to 3
positive
integer
positive
integer
positive
integer
The following sampled audio WAVE file (.wav) formats are supported:
mono 8 kHz G.711 μ-Law
•
• G.711 A-Law
• L16/16000 (16-bit, 16 kHz sampling rate, mono)
L16/16000 is not supported on SoundPoint IP 301phones, and SoundStation IP
4000 phones.
The phone uses built-in wave files for some sound effects. The built-in wave
files can be replaced with files downloaded from the boot server or from the
Internet, however, these are stored in volatile memory so the files will need to
remain accessible should the phone need to be rebooted. Files will be
truncated to a maximum size of 300 kilobytes.
Interpretation
Frequency for this component in Hertz; up to four
chord-set components can be specified (y=1, 2, 3, 4).
Level of this component in dBm0.
On duration in milliseconds, 0=infinite.
Off duration in milliseconds, 0=infinite.
Specifies how many times the ON/OFF cadence is
repeated, 0=infinite.
Configuration Files
A - 27