Heat & Glo LUX60 Owner's Manual page 50

- Remove three cover plates by removing two screws
from each plate. See Figure 15.3.
Remove
Figure 15.3 Remove Three Plates
- Remove three outside burner tubes by removing two
screws on each tube. See Figure 15.4.
Figure 15.4 Remove Outside Burner Tubes
- Outside burner tube air shutters may be adjusted as
shown in Figure 15.5.
Figure 15.5 Outside Burner Tube Air Shutter Adjustment
50
Plates
Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11
• Center Burner Tube Air Shutter
- Remove decorative steel log assembly by removing
3 screws, lifting up and out (Figure 15.6).
Figure 15.6 Remove Decorative Steel Log Assembly
- Center burner tube air shutter is now accessible with
short phillips screw driver (see Figure 15.7).
Figure 15.7 Adjust Center Burner Tube Air Shutter
- Loosen phillips screw and turn air shutter for optimum
fl ame appearance.