Heat & Glo LUX60 Owner's Manual page 19

• Remove decorative steel log assembly by removing 3
screws, lifting up and out (Figure 3.10).
Figure 3.10 Remove Decorative Steel Log Assembly
• Remove center burner tube by removing two screws.
See Figure 3.11.
Figure 3.11 Remove Center Burner Tube
• Remove pilot shield by removing four screws. See Figure
3.12.
Figure 3.12 Remove Pilot Shield
• Remove hearth pan by removing 7 screws. See Figure
3.13.
Figure 3.13 Remove Hearth Pan
• Remove refractory:
-
-
-
• Clean porcelain panels with a soft, dry cloth.
• Reinstall refractory, center burner tube, decorative steel
log assembly, outside burner tubes, cover plates, glass
rocks.
Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11
Remove
4 Screws
Remove six bottom screws in refractory, then remove
the two top screws.
Pull front refractory fl anges inward until they clear
the fi rebox fl ange.
Slide refractory forward while lifting back of refractory
over pilot. Continue sliding forward evenly until
refractory is out.
19