Heat & Glo LUX60 Owner's Manual page 18

Clean Porcelain Panels
Frequency: As needed
By: Qualifi ed Service Technician
Tools needed: Protective gloves, phillips screwdriver
• Disconnect power to fi replace.
• Remove the "L" plates and inner surround frame (see
surround install). This will make the valve compartment
and glass accessible. (Refer to Section 3.A. Glass
Cleaning.)
• Remove glass rock, set aside.
Note: Mark and note burner tube locations.
They are not interchangeable (Figure 3.7).
LH Burner Tube Back Burner Tube
Figure 3.7 Burner Tube ID
18
•
Figure 3.8
•
Figure 3.9
RH Burner Tube
Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11
Remove three cover plates by removing two screws from
each plate. See Figure 3.8.
Remove
Plates
Remove Three Plates
Remove three outside burner tubes by removing two
screws on each tube. See Figure 3.9.
Remove Outside Burner Tubes