Step 9. Finishing - Heat & Glo Pier-HV-IPI Owner's Manual

Step 9. Finishing

Figures 39 and 40 show the minimum vertical and corresponding
maximum horizontal dimensions of fireplace mantels or other
combustible projections above the top front edge of the fireplace. See
Figures 4 and 5 for other fireplace clearances. Only non-combustible
materials may be used to cover the black fireplace front.
WARNING: WHEN FINISHING THE FIREPLACE, NEVER
!
OBSTRUCT OR MODIFY THE AIR INLET/OUTLET GRILLES
IN ANY MANNER.
MANTEL
7"
6"
5"
4"
3"
2"
1"
9"
8"
7"
6"
5"
HOOD
*
Minimum Vertical and Maximum Horizontal
Figure 39.
Dimensions of Combustibles above Fireplace
MANTEL
6"
5"
4"
3"
2"
1"
15"
14"
13"
12"
HOOD
Minimum Vertical and Maximum Horizontal
Figure 40.
Dimensions of Combustibles above Fireplace
40
12"
11"
10"
9"
8"
* Mantel dimensions shown are
for standard hood on models:
16"
15" PIER-HV-IPI, LCOR-HV-IPI,
14"
13" and RCOR-HV-IPI.
12"
11"
10"
* To use mantel dimensions
shown the fireplace must have
the standard hood replaced
with a larger hood (060-143)
on model: ST-HV-IPI.
NOTE: 12" mantel
at 16" above hood.
12"
11"
10"
9"
* Mantel dimensions shown are
8"
for standard hood on model:
7"
ST-HV-IPI
23"
22"
21"
20"
19"
18"
17"
16"
*
NOTE: 12" mantel at
23" above hood.
Heat & Glo • PIER-HV-IPI, ST-HV-IPI, L&R-COR-HV-IPI • 2005-900 Rev. K • 11/06
CAUTION: IF JOINTS BETWEEN THE FIN-
ISHED WALLS AND THE FIREPLACE SUR-
ROUND (TOP AND SIDES) ARE SEALED, A
300° F. MINIMUM SEALANT MATERIAL
MUST BE USED. THESE JOINTS ARE NOT
REQUIRED TO BE SEALED. ONLY NON-
COMBUSTIBLE MATERIAL (USING 300° F.
MINIMUM ADHESIVE, IF NEEDED) CAN BE
APPLIED AS FACING TO THE FIREPLACE
SURROUND. SEE THE DIAGRAM BELOW.
NOTE: Sheetrock or other combustible mate-
rial such as wood can be placed on the top
edge and sides of the fireplace.
ST-HV-IPI
PIER-HV-IPI and L&RCOR-HV-IPI
Figure 41. Sealant Material
Hearth Extensions
A hearth extension may be desirable for
aesthetic reasons. However, ANSI or CAN/CGA
testing standards do not require hearth
extensions for gas fireplace appliances.
TOP EDGE
SIDE EDGE
0" GAP
TOP EDGE
SIDE EDGE
0" GAP