Placing The Ember Material; Ember Light Bulb Replacement - Heat & Glo Pier-HV-IPI Owner's Manual

Placing the Ember Material

Ember material is shipped with this gas fireplace. The bag
labeled Glowing Ember (050-721) is standard glowing em-
ber material.
To place the ember material:
• Remove the glass door from the unit.
• Place dime size pieces of ember material about 1/2 inch
apart near port holes in burner top. Do NOT press em-
bers into burner ports. Cover the top of the burner with a
single layer of ember material.
• Save the remaining ember materials for use during fire-
place servicing. The bag of embers provided is sufficient
for 3 to 5 applications.
• Replace the glass door and a front trim door on the unit.
Figure 50. Placement of the Ember Material
Heat & Glo • PIER-HV-IPI, ST-HV-IPI, L&R-COR-HV-IPI • 2005-900 Rev. K • 11/06

Ember Light Bulb Replacement

In the lower gas valve compartment you will find three ac-
cess panels for the three light bulbs (see Figure 51).
ACCESS PANEL
Figure 51.
Using a 5/16" nut driver remove the two bolts (see
Figure 52).
ACCESS PANEL
Figure 52.
Pull the access panel to expose the light bulb. Wearing
clean cotton gloves replace the bulb. Any skin oils which
get on a new bulb will greatly shorten the life of the bulb.
The bulb can be cleaned with isopropyl alcohol (see Figure 53).
Figure 53
43