Filling The Crankcase With Oil - Hayter 455E Operator's Manual

2
Installing the Fuel Tank and
the Fuel Line
Parts needed for this procedure:
2 Self-tapping screw
1 Fuel tank
Procedure
1. Slide the end of the fuel line onto the elbow fitting
(Figure 4).
1. Fuel tank
2. Elbow fitting
2. Secure the fuel line in place with the fuel line clamp
(Figure 4).
3. Slide the plastic clips on the front of the fuel tank
onto the fuel tank mount (Figure 5).
Figure 4
3. Fuel line
4. Fuel line clamp
1. Plastic clip (2)
4. Secure the bottom of the fuel tank to the fuel tank
bracket by installing the self-tapping screws from the
bottom. Torque the screws to 40 to 50 in-lb (4.5
to 5.6 N-m). Do not overtighten the screws.
3

Filling the Crankcase with Oil

No Parts Required
Procedure
The engine crankcase is shipped without oil. You must
fill it with approximately 30 oz. (0.88 L) of oil before
starting the engine. Refer to Checking the Engine Oil
Level in the Operation section for oil specifications and
instructions.
8
Figure 5