Advertisement
10. Attach the Seat (9) to the Seat Bracket (11) with four
M6 x 16mm Button Screws (81) and four M6 Washers
(75). Start aH four Button Screws before tightening
any of them.
10
81
81
11. Attach the Seat Bracket (11) to the Seat Carriage (41)
with four M8 x 19mm Button Screws (77) and four M8
SpJit Washers (55). Start aH four Button Screws
before tightening
any of them.
11
77
55
12. Identify the Left PedaJ (22), which is marked with an
"L." Using an adjustabJe wrench, firmly tighten
the
Left PedaJ counterclockwise
into the Left Crank
Arm (24). Tighten the Right Pedal (not shown) clock-
wise into the Right Crank Arm (not shown). Important:
Tighten
both Pedals as firmly
as possible.
After
using the exercise
cycle for one week, retighten
the PedaJso
Adjust the strap on the Left PedaJ (22) to the desired
position, and insert the end of the strap into the Jatch
on the Left Pedal. Adjust the strap on the Right
Pedal (not shown) in the same way.
12
Strap.
Latch
13. Make sure that aH parts are properJy tightened
before you use the exercise cycle. Note: After assembJy is
completed, some extra parts may be Jeft over. PJace a mat beneath the exercise cycle to protect the floor.
Advertisement
