Advertisement
5.
5
The Console (4) requires four "D" batteries (not includ-
ed); alkaline batteries are recommended, ff_POR-
TANT: Jf the exercise
cycle has been exposed
to
cold temperatures,
allow it to warm to room tem-
perature
before inserting
batteries
into the
ConsoJe. tf you do not do this, the consoJe dis-
plays or other electronic
components
may become
damaged.
Remove the battery covers from the back
of the Console. Next, insert four batteries into the bat-
tery compartments;
make sure that the batteries
are
oriented
as shown by the diagrams
inside the bat-
tery compartments.
Then, reattach the battery cov-
ers.
Note: The Console (4) can be operated with an option-
al power supply instead of batteries. To purchase
a
power supply, call the toll=free telephone
number
on the front cover of this manual. Plug one end of
the power supply into the jack at the front of the exer-
cise cycle. Plug the other end of the power supply into
an appropriate outlet that is properly installed in accor-
dance with all local codes and ordinances.
Batteries
Battery
Covers
/
Batteries
Attach the Handlebar (39) to the Upright (2) with four
M6 x 30mm Button Screws (37).
\
39
37
37
While another person holds the Console (4) near the
Handlebar (39), connect the wire harness on the
Console to the Main Wire Harness (43). Next, connect
the pulse wire on the Console to the Pulse Wire (51) in
the Handlebar (39). Note: The remaining wire on the
Console is used during the manufacturing process;
disregard this wire.
Insert the excess wiring downward into the Upright (2).
Attach the Console (4) to the Handlebar (39) and the
Upright with four M4 x 16mm Round Head Screws
(80). Be careful to avoid pinching the Wires (43, 51).
8O
Wire
Harness
39
43
Pulse
Wire
Avoid pinching
the Wires (43, 51)
during this step
Advertisement
