Advertisement
11. Apply grease to a Pedal Arm Axle (64).
Next, slide an M8 Washer (97) and an Axle
Spacer (77) onto an M8 x 13mm Screw (82), and
tighten the Screw a few turns into the Pedal Arm
Axle (64).
While a second person holds the front end of the
Right Pedal Arm (58) inside the bracket on the
Right Upper Body Leg (60), insert the Pedal Arm
Axle (64) into both parts.
Slide an M8 Washer (97) and an Axle Spacer
(77) onto another M8 x 13mm Screw (82), and
tighten the Screw a few turns into the Pedal Arm
Axle (64). Then, tighten
both Screws at the
same time.
Repeat this step on the other side of the
elliptical.
See assembly step 4. Tighten the M10 x 25mm
Screws (99).
11
60
Grease
64
77
97
12. Orient the Shield Cover (75) assembly as shown.
While a second person holds the Shield Cover
(75) assembly near the Upright (4), connect the
Fan Extension Wire (146) to the Fan Wire (136).
Tip: Avoid pinching the wires. Press the
Shield Cover (75) onto the Left and Right Shields
(73, 74).
12
75
Avoid pinching
the wires
73, 74
11
Advertisement
