Magic Chef CGB3740ADH Owner's Manual page 30

iliiiiiiii!iliiiiii
iiiiiiliiiiiii!i! iiili!iliiiiiiiiiiiiiiiiiiiliii iii!iiiii!iii!iiliiiiiiiiiii i iiiii!!
Surface burner fails to light a. power supply not connected a.
b_
C.
d.
Bumer flame uneven
Surface burner flame
• lifts off port
• yellow in color
e°
f.
air in the gas line
clogged burner port(s)
surface control not completely
turned to the LITE position or turned
too quickly from the LITE position
power failure
sealed burner models: Burner will
not light if the ignitor is damaged,
soiled, wet or if the port directly
below the ignitor is blocked.
connect power, check circuit
breaker or fuse box
b. see page 7 for instructions on
bleeding air from the gas line
c. clean ports with straight pin
d, turn control to the LITE position until
the burner ignites, then turn control
to desired flame size
e. see page 7 to light burner during a
power failure
f. clean and dry burner head. If broken
or damaged, call a serviceman.
a, clogged burner port(s) a, clean ports with straight pin
a. air/gas mixture not proper
b. no pan in place
NOTE: Lifting of flame is normal for
sealed burners. Some yellow tipping
with LP gas is normal and acceptable.
a. call serviceman to adjust burner
b. always place pan on grate before
lighting burner.
NOTE: Be sure installer properly
adjusted range at time of installation.
Surface burner ignitor a.
producting clicking sound
b,
C.
control knob is in the LITE position.
NOTE: The life of the ignition
system may be shortened if the
knob is left in the LITE position.
surface control switch is moist as a
result of cleaning the range.
malfunctioning switch
a. be sure ALL surface burner control
knobs are in the OFF position or are
adjusted to the desired flame
setting
b. allow switch to dry then relight
burner
c. call serviceman to check
Oven burner fails to light a. power supply not connected a. connect power, check circuit
breaker or fuse box
b. power failure b. oven will not operate during a power
failure
c. oven incorrectly set c. See pages 5 or 12
d. Automatic Oven Cooking feature d. See page 16
incorrectly set
Popping sound heard when
burner extinguishes
This is a normal sound that occurs with some types of gaswhen a hot burner is turned
off. The popping sound is not a safety hazard and will not damage the appliance.
Clock and/or oven light
does not work
a. power supply not connected
b. bulb may be loose or burned out
c. malfunctioning switch, starter or
ballast
d. malfunctioning clock or loose wiring
a. connect power supply, check circuit
breaker or fuse box
b. tighten or replace light bulb
c. call serviceman to check
d. call serviceman to check
Moisture condensation on
oven window
a. it is normal for the window to fog
during the first few minutes the oven
is on
b. cloth saturated with water is used to
clean the window
a. leave door ajar for one or two
minutes to allow moisture to escape
b. Use a damp cloth to clean window to
prevent excess water from seeping
between the panels of glass