Dryer Features - GE Profile PTDN850GM0WW Owner's Manual And Installation Instructions

Dryer Features.
GEAppliances.com
Duct Sensing
The duct blockage system automatically
monitors, detects and alerts you to blockages
in the ductwork. Blocked ductwork can
degrade dryer performance by reducing
airflow from the dryer. If you observe the
display window with the message, "CLg" it is
time to clean your exhaust ducting in order to
increase efficiency and reduce dry times.
Screw
Changing the Drum Lamp
Before replacing the drum lamp, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker.
The drum lamp is located at the top left of
the door frame.
1 Removethe screw holding the drum lump
shield in place.
2 Slide the shield up and remove.
21 Removethe bulb and replace with a
iS-watt, 120-volt candelabra-base bulb.
4 Replacethe lump shield and screw.
Using the Drying Rack
A handy drying rack may be used for drying
delicate items such us washable sweaters.
Hook the rack over the lint filter so the rack
extends into the dryer drum.
NOTE:
The drying rack should only be used with
the TIMEDRYcycle. It is also strongly
recommended when drying sneakers.
Do not use this drying rack when there are
other clothes in the dryer.
Using the Steam Cycles
Add Water
Before using a Steam Cycle,the water tank
must be filled with water up to the MAXline.
If not, the ADD WATERlight will blink. Make
sure that the water tank is filled with water
and the cartridge is completely connected.
Turn the dryer off and then restart the Steam
Cycle.
1. Turn the dryer off by pressing the POWER
button.
2. Open the lid.
21.Move the lever to open.
4. Lift out the water tank and open the tank
lid.
5. Fillthe tank to the HAX water line with
water.
6. Placethe water tank back into the barrel
and move the lever to close.
7. Close the lid, press the POWERbutton and
select the cycles desired.
NOTES
+Only use water. Do not fill the water tank
with foreign substances, rinse agents, or
detergents.
+Before moving the dryer, make sure the
water tank is empty.
Do not use distilled water; the water level
sensor in the steam generator will not work.
+Be careful while filling the water tank to
avoid overflow and spilling.
+Wipe up any spilled water around the water
tank and the drawer before starting the
dryer.
11