Cycle Options - GE Profile PTDN850GM0WW Owner's Manual And Installation Instructions

About cycle options(cong.
NOTE: Not oil features ore available on oil dryer models.
_E×TENDED']
oIDAM'I
ALERT
Estimated Time Remaining
Displays the approximate time remaining
until the end of the cycle.
Asthe cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will "race" in the display.This
means the dryer is continuously monitoring
Extended Tumble
the amount of moisture in the load. The lights
will continue until the dryer sensesa low level
of moisture in the load. At that point, the
dryer will calculate and display the
approximate time remaining.
Minimizes wrinkles by adding brief periods of
tumbling after cycle ends. The dryer will
tumble without heat for !O seconds followed
by no tumbling for 5 minutes and repeat for
up to 3 hours after clothes are dry. Thedryer
is in EXTENDED TUMBLEwhen the
ESTIMATEDCYCLE TIMEdisplay is
illuminated in a circular pattern.
The light beside the button will light up when
EXTENDED TUMBLEison.
NOTE: It is normal for the drum to pause
for short periods o1:time during EXTENDED
TUMBLE.
Damp Alert
This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP
ALERTwill only beep when this option is
selected (dry cycle keeps running).
The light beside the button will light up when
DAMPALERTis on.
NOTE: Onlg for LESSDRY,DRY,MOREDRY
and EXTRADRYsensor drg selections.
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
DELAY ]
0 L
START J
Delag Start
Use to delay the start of your dryer.
I. Chooseyour dry cycle and any options.
2. Pressthe DELAYSTARTbutton. You
can change the delay time in !-hour
increments (up to 2/4hours) each time
you press the DELAYSTARTbutton. Stop
pressing the button when your desired
time is displayed.
3. Pressthe START/PAUSE button to start
the countdown.
The countdown time will be shown in the
ESTIMATED TIMEREMAININGdisplay.
The light beside the button will light up when
DELAYSTART is on.
NOTES:
I If the door is opened while the drger is in
DELAY,the countdown time will continue
to count down the delabl time. If the door
is not closed and the countdown time
expires, the cgcle will not start until the
door is closed and the START/PAUSE
button is pressed.
B
You can delag the start of a dryer cgcle
up to 24 hours.
Rack Drg
Use the RACKDRYfeature to dry shoes and
hats.
1. Insert the drying rack (refer to page 11 for
the correct placement).
2. Placegarment in the center of the rack
and close the door.
3. Pressthe RACKDRYbutton.
4. Set TIME.(refer to page 8 for instructions).
5. Pressthe STARTPAUSEbutton.
The light beside the button will light up when
RACKDRY is on.
NOTES:
I Do not use the drying rack without
selecting the RACKDRY cycle.
I Do not change the cgcle setting off the
timed dry cgcle.
I When the RACK DRY feature is selected
no other cycle setting can be chosen.An
invalid tone will sound if the cycle knob
is turned.
10