Before You Begin - GE Profile PTDN850GM0WW Owner's Manual And Installation Instructions

I
I
stolloti
str ct"
Dr er
PTDN800, PTDN805, PTDS850, and PTDS855
ln Canada, call 1.800.561.3344, or visit geappliances.ca
BEFORE YOU BEGIN
Reed these instructions completelg and cerefuJlg.
•
iMPORTANT-
save these instructions for local
electrical inspector's use.
• iMPORTANT-Observe aU governing codes end
ordinances.
• Install the clothes dryer according to the manufacturer's
instructions and local codes.
• Note to Installer - Be sure to leave these instructions
with the Consumer.
• Note to Consumer - Keep these instructions for future
reference.
• Clothes dryer installation must be performed by u
qualified installer.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or
discur@& remove the dryer door.
• Service information and the wiring diagram are located
in the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Install the dryer where the temperature is above 50°F
for satisfactory operation of the dryer control system.
• Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
FOR YOUR SAFETY:
,WARNING
Use only rigid metal or flexible metal 4-inch
diameter ductwork for exhausting to the
outdoors. Never use plastic or other combustible
easy-to-puncture ductwork.
This appliance must be properly grounded and
installed as described in these instructions.
Do not install or store appliance in an area where
it will be exposed to water and/or weather.
The National Fuel Gas Code restricts installations
of gas appliances in garages. They must be 18
inches off the ground and protected by a barrier
from vehicles.
. Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer
control system.
FOR GAS MODELS ONLY:
NOTE: Installation end service of this dryer must
be performed by e qualified installer, service
agency or the gas supplier.
in the Commonwealth of Massachusetts:
. This product must be installed by
o licensed plumber or gas fitter.
,,When using bell-type gas shut-off valves,
they shall be T-handle-type.
. A flexible gas connector, when used,
must not exceed 3 feet.
14