Troubleshooting Tips - GE Profile PTDN850GM0WW Owner's Manual And Installation Instructions

Before gou call for service.., j
Troubleshooting Tips
Save time and monebt! Review the chart below first and
you may not need to call for service.
Possible Cause What To Do
Dryer won't Control panel is asleep • This is normal. PressPOWER.
operate Drger is unplugged • Make sure cord is plugged securely into a working outlet.
Controls ore not set properlg , Make sure the cycle was set correctly, close the lid and
press START.
Fuse is blown/circuit breaker , Check house circuit breakers/fuses. Replacefuses or reset
is tripped breaker. NOTE:Electricdryers use two fuses or breakers.
Electronics need to be reset • Unplug dryer,wait 2 minutes, plug back in and press POWER.
STARTwas not pressed after • PressSTART.
a cgcle was set
Door was opened during the , Closethe door and reset cycle, to the beginning if necessary.
drg cgcle PressSTART.
Drger is too cold , If the dryer has been exposed to temperatures below freezing
for an extended period of time, allow it to warm up before
pressing POWER.Otherwise, the display will not come on.
CLg in displag Exhaust duct blocked , Check all of your exhaust ducting including transition ducts,
window wall caps and around turns. Contact a qualified service
provider if necessary.
Normal Operating Sounds
The following ore normal sounds gou mog hear:
Description
Thumping noise when. If the dryer has not been used for an extended period of time, you may hear a thumping noise
drum rotates from temporary flat spots on the drum support rollers.The noise will go away after use.
34