GE JGAS02 Owner's Manual And Installation Instructions page 8

!_ii!!]!!!i!!!!!!i!!!!!!!i!:iiii:::_!!!!
i_:!i:!i!!i;ii!!!{!!!!!!!i::_!_:_::i'!!
_;iii!!{iiii/iii/i_i{i?:b_
_i{iiiiii/iii/iiii!!i_i_i_Ji_iiiiiii
iii_i!_i_lili!lilil
g
.g
#.
e,
Usingthe gas surface burners.
Throughout this manual, features and appearance may vary from your model
Surface LightingInstructionsfor Electric Ignition Models
Thesurface burners on somemodels arelit by
electricignition,eliminating theneedforstanding
pilot lightswith constantly burning flames.
In case of a powerfailure, you can light
the surface burners on your range wifll
a match. HoM a lit match to the burner,
then mrn the knob to the LITE position.
Use extreme caution when lighting burners
this way.
The electrode of die spark ignitor is
exposed. When one burner is turned
to
UTE,
all the burners spark. Do not
atmmpt to disassemble
or clean
around any burner while another
burner is on. An elecuic shock m W
result, which could cause you to
knock over hot cookwaIe.
Surface burners in use when an
electrical power failure occurs will
continue to operate normally.
Surface LightingInstructionsfor StandingPilot Models
Thesurface burners on theseranges have
standing pilots thatmustbe lit initiall_
Tolight them:
%
@
%
Be
stlre stlrf_ce b/lIneY control
knobs are in the OFFposition.
Lift die cooktop up and prop it
open widi die prop rod provided
(see
the Careand cleaningof the
range section).
Locate the 2 pilot ports and light
each of them with a match.
To avoid pilot outage, slowly lower
the cooktop aRer lighting the pilots.
Surface Burner Controls
Theknobs that turn the surfaceburners on and
off are located on the control panel on the front
of the range. Thetwo surface knobson the left
control the left front and left rear burners. The
two surfaceknobson the right control the right
front andright rear burners.
ToUsea SurfaceBurner
%
Push the control knob in and mrn it
to Life (HI on pilot models). On
electric ignition models, you will
hear a little clicking noise--the
sound of the electric spark igniting
the burner
After the burner ignites, mrn the
knob to adjust the flame size.
After Lighting a Burner
II
m
Check to be sure the burner you
turned on is the one you want to use.
Do not operate a burner for an
extended period of fiIIle without
cool<ware on the grote. The finish on
the gram may chip without cool<ware
to absorb the heat.
II
Be sure d_e burners and grates are
cool before you place your hand, a
pot holder; cleaning cloths or other
materials on them.
8